3

ABS warning light illuminates

POSSIBLE CAUSE

• ABS HU/CM or DSC HU/CM malfunction

• Instrument cluster malfunction

• Connector or pin malfunction

• Short circuit in wiring harness between CAN-L, CAN-H and GND

• Open circuit in CAN wiring harness (CAN-L, CAN-H)

• CAN wiring harness (CAN-L, CAN-H) short each other

STEP

INSPECTION

ACTION

1

• Start the engine.

• Does the ABS warning light turn off?

Yes

Troubleshooting completed.

No

Go to the next step.

2

• Are there a number of warning lights illuminated?

Yes

Go to Step 4.

No

Go to the next step.

3

• Start the instrument cluster input/output check mode.

• Does the ABS warning light turn off with a check code other than 26?

Yes

Inspect the ABS HU/CM or DSC HU/CM.

No

Replace the instrument cluster.

4

• Disconnect the negative battery cable.

• Measure the resistance between the DLC-2 terminals F and E.

• Is the resistance 54—66 ohms?

Yes

Go to the next step.

No

Go to Step 6.

5

• Inspect the DLC-2 terminals F and E for short to power supply or GND.

• Is there any malfunction?

Yes

Inspect the wiring harness and CAN system-related module.

Repair or replace the malfunctioning part.

No

Replace the instrument cluster.

6

• Turn the ignition switch off.

• Inspect the instrument cluster connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).

• Are the terminals normal?

Yes

Go to the next step.

No

Repair or replace the terminal.

7

• Disconnect the negative battery cable.

• Measure the resistance between the instrument cluster connector terminals 1J and 1L.

• Is the resistance 114—126 ohms?

Yes

Inspect the wiring harness and CAN system-related module.

Repair or replace the malfunctioning part.

No

Replace the instrument cluster.