2

All meters and gauges do not operate

POSSIBLE CAUSE

• Instrument cluster malfunction

• Connector or pin malfunction

• Fuse malfunction

• Open or short circuit in power supply (IG1) wiring harness

• Open or short circuit in GND wiring harness

STEP

INSPECTION

ACTION

1

• Turn the ignition switch to the ON position.

• Inspect the following:

• Does the odometer/tripmeter illuminate?

• Does the fuel gauge operate?

• Does the MIL turn off within approx. 3 s?

Yes

Troubleshooting completed.

No

Go to the next step.

2

• Inspect the METER fuse.

• Is the fuse normal?

Yes

Go to the next step.

No

Replace the fuse.

• If the fuse is melted, inspect the wiring harness for a short to ground. Repair or replace the wiring harness, then replace the fuse.

3

• Turn the ignition switch to LOCK position.

• Remove the instrument cluster.

• Disconnect the instrument cluster connector.

• Inspect the voltage between instrument cluster wiring harness-side connector terminal 1G and terminal 1E.

• Turn the ignition switch to the ON position.

• Is the voltage B+?

Yes

Go to the next step.

No

Inspect the suspect wiring harness, then repair or replace.

4

• Turn the ignition switch off.

• Inspect the instrument cluster connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).

• Are the terminals normal?

Yes

Replace the instrument cluster.

No

Repair or replace the terminal.