< Previous   Next >

2008 - MX-5 - Brakes

DTC B2477 [ABS]



DTC

B2477

ABS HU/CM configuration

DETECTION CONDITION

  • Configuration setting failure is detected.

POSSIBLE CAUSE

  • Module configuration procedure was not completed properly.


Diagnostic procedure

STEP

INSPECTION

ACTION

1

VERIFY CONFIGURATION
  • Has the ABS HU/CM configuration been performed?

Yes

Go to the next step.

No

Perform configuration using the M-MDS.

(See ABS CONFIGURATION.)

2

VERIFY DTC TROUBLESHOOTING COMPLETED

Yes

Repeat the inspection from Step 1.

If the malfunction recurs, replace the ABS HU/CM.

(See ABS HU/CM REMOVAL/INSTALLATION.)

No

Go to the next step.

3

VERIFY AFTER REPAIR PROCEDURE
  • Are any other DTCs present?

Yes

Go to the applicable DTC inspection.

(See ON-BOARD DIAGNOSIS[ABS].)

No

DTC troubleshooting completed.




< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.