DTC P0507

Idle speed control system RPM higher than expected

DETECTION CONDITION

• Actual idle speed is higher than expected by 200 rpm for 14 s, when the brake pedal is depressed (brake switch is on) and steering wheel is held straight ahead (power steering pressure (PSP) switch is off).

NOTE:

• If atmospheric pressure is less than 72.3 kPa {542 mmHg, 21.3inHg} or intake air temperature is below –10 °C {14 °F}, the PCM cancels diagnosis of P0507.

Diagnostic support note

• This is a continuous monitor (CCM).

• The MIL illuminates if the PCM detects the above malfunction conditions in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.

• PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.

• FREEZE FRAME DATA is available.

• The DTC is stored in the PCM memory.

POSSIBLE CAUSE

• Electronic throttle control system malfunction

• Vacuum hose misconnection

• PCM malfunction

STEP

INSPECTION

ACTION

1

• Has FREEZE FRAME DATA been recorded?

Yes

Go to the next step.

No

Record the FREEZE FRAME DATA on the repair order, then go to the next step.

2

• Verify related Service Bulletins and/or on-line repair information availability.

• Is any related repair information available?

Yes

Perform repair or diagnosis according to the available repair information.

• If the vehicle is not repaired, go to the next step.

No

Go to the next step.

3

• Turn the ignition switch off, then to the ON position (Engine off).

• Verify PENDING CODE or stored DTCs using the M-MDS.

• Are other DTCs present?

Yes

Repair the applicable DTCs.

(See DTC TABLE [LF].)

No

Go to the next step.

4

• Are vacuum hoses connecting accurately?

Yes

Go to the next step.

No

Reconnect vacuum hose accurately, then go to the next step.

5

• Make sure to reconnect all disconnected connectors.

• Start the engine.

• Clear the DTC from the PCM memory using the M-MDS.

• Depress the brake pedal for 14 seconds or more.

• Is the PENDING CODE for this DTC present?

Yes

Replace this PCM, then go to the next step.

(See PCM REMOVAL/INSTALLATION [LF].)

No

Go to the next step.

6

• Perform “AFTER REPAIR PROCEDURE”.

  (See AFTER REPAIR PROCEDURE [LF].)

• Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [LF].)

No

Troubleshooting completed.