The purpose of this test mode is to confirm the result of OBD-II monitor diagnostic test results. The result values stored when particular monitor is completed are displayed. If the monitor is not completed, initial value is displayed.
|
OBD Monitor ID |
Test ID |
Description |
Related system |
Scaling ID |
Unit |
|
01 |
80 |
HO2S (Front) lean-to-rich response time (calculated) |
HO2S |
20 |
Ratio |
|
01 |
81 |
HO2S (Front) rich-to-lean response time (calculated) |
20 |
Ratio |
|
|
01 |
82 |
HO2S (Front) lean-to-rich response time (calculated) |
20 |
Ratio |
|
|
01 |
83 |
HO2S (Front) rich-to-lean response time (calculated) |
20 |
Ratio |
|
|
02 |
03 |
Low HO2S (Rear) voltage for switch time calculation (constant) |
0A |
Voltage |
|
|
02 |
04 |
High HO2S (Rear) voltage for switch time calculation (constant) |
0A |
Voltage |
|
|
02 |
05 |
HO2S (Rear) rich-to-lean response time (calculated) |
10 |
Time |
|
|
21 |
80 |
HO2S (Front) and HO2S (Rear) switching time ratio |
Catalyst |
20 |
Ratio |
|
31 |
83 |
EGR pressure variation |
EGR |
17 |
Pressure |
|
3A |
80 |
EVAP system leak detection pump large leak check |
EVAP |
0D |
Current |
|
3B |
80 |
EVAP system leak detection pump small leak check |
0D |
Current |
|
|
3C |
80*1 |
EVAP system leak detection pump very small leak check |
05 |
Raw value |
|
|
3D |
80 |
Purge flow monitor |
0D |
Current |
|
|
A2 |
0B |
Cylinder No.1 average misfire counts for last 10 DC |
Misfire |
24 |
Counts |
|
A2 |
0C |
Cylinder No.1 misfire counts for last/current DC |
24 |
Counts |
|
|
A3 |
0B |
Cylinder No.2 average misfire counts for last 10 DC |
24 |
Counts |
|
|
A3 |
0C |
Cylinder No.2 misfire counts for last/current DC |
24 |
Counts |
|
|
A4 |
0B |
Cylinder No.3 average misfire counts for last 10 DC |
24 |
Counts |
|
|
A4 |
0C |
Cylinder No.3 misfire counts for last/current DC |
24 |
Counts |
|
|
A5 |
0B |
Cylinder No.4 average misfire counts for last 10 DC |
24 |
Counts |
|
|
A5 |
0C |
Cylinder No.4 misfire counts for last/current DC |
24 |
Counts |