DTC

Security light flashing pattern

-

Only one key ID number is registered

M-MDS display

Keyless control module

B1213

Instrument cluster

-

PCM

P1260

POSSIBLE CAUSE

• Only one registered key

STEP

INSPECTION

ACTION

1

VERIFY NUMBER OF REGISTERED KEYS

• Using the M-MDS, perform the PID/data monitor inspection and confirm the number of registered keys.

  (See PID/DATA MONITOR TABLE [IMMOBILIZER SYSTEM (ADVANCED KEYLESS SYSTEM)].)

• Are two or more keys registered?

Yes

Replace the instrument cluster and perform the resetting procedure for the immobilizer system when replacing the instrument cluster.

(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

(See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING [ADVANCED KEYLESS SYSTEM].)

No

• Using the M-MDS, clear the key ID number and register a new key if necessary.

  (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING [ADVANCED KEYLESS SYSTEM].)

• Go to the next step.

2

VERIFY DTC

• Using the registered key, turn the ignition switch to the ON position.

• Is the DTC displayed again?

• Security light: -

• M-MDS: B1213/-/P1260

Yes

Replace the instrument cluster and perform the resetting procedure for the immobilizer system when replacing the instrument cluster.

(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

(See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING [ADVANCED KEYLESS SYSTEM].)

No

DTC troubleshooting completed.