Home

< Previous   Next >

2008 - MX-5 - Body and Accessories

CENTER PANEL UNIT REMOVAL/INSTALLATION

NOTE:

1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
3. Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION.)
4. Remove the knee bolster. (See KNEE BOLSTER REMOVAL/INSTALLATION.)
5. Remove the side wall. (See SIDE WALL REMOVAL/INSTALLATION.)
6. Check if the vehicle has the installation bolt or not at the position shown in the figure from the underside of the driver-s seat.
7. Remove in the order indicated in the table.



1

Screw

2

Center panel unit

(See Center Panel Unit Removal Note.)

3

Connector

4

Antenna feeder plug


8. Install in the reverse order of removal.

CAUTION:

Center Panel Unit Removal Note

1. Pull the center panel unit outward, detach clip A from the dashboard, and then remove the center panel unit.

2. When removing the center panel unit, disconnect the audio unit connector (24-pin) first to aid in disconnecting other connectors and the antenna plug.


< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.