Home

< Previous   Next >

2008 - MX-5 - Body and Accessories

B-PILLAR UPPER TRIM INSTALLATION [DETACHABLE HARDTOP]

NOTE:

WARNING:

1. When installing a new B-pillar upper trim, follow the procedure below:
a. Remove the adhesive remaining on the body using razor.
b. Remove any grease or dirt from the adhesion surface of the body.
2. When reusing the B-pillar upper trim, follow the procedure below:
a. Remove the adhesive remaining on the B-pillar upper trim and the body using a razor.
b. Remove any grease or dirt from the adhesion surface of the B-pillar upper trim and the body.
c. Apply primer to the bonding area of the B-pillar upper trim.
d. Attach double‐sided adhesive tape to the B-pillar upper trim as shown.

NOTE:

  • Use 3M GT7108 double-sided adhesive tape or equivalent.

3. Peel off the backing of the double‐sided adhesive tape, then install the B-pillar upper trim to the detachable hardtop.


< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.