Home

< Previous   Next >

2008 - MX-5 - Body and Accessories

FRONT HEADER TRIM REMOVAL/INSTALLATION

Removal

CAUTION:

1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
3. Remove the female wedge. (See CONVERTIBLE TOP DISASSEMBLY/ASSEMBLY.)
4. Remove the map light. (See MAP LIGHT REMOVAL/INSTALLATION.)
5. Remove the A-pillar trim. (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
6. Remove the screws.

7. Pull the front header trim toward you, then disengage the clips A and pin B from the body.
8. Remove the front header trim.

Installation

CAUTION:

1. Install the pin A and clip B.

2. Pull down the sunvisor on the right, then install pin C and clips D.
3. Pull down the sunvisor on the left, then install pin E and clips F.
4. Install the screw.
5. Install the A-pillar trim. (See A-PILLAR TRIM REMOVAL/INSTALLATION.)
6. Install the map light. (See MAP LIGHT REMOVAL/INSTALLATION.)
7. Install the female wedge. (See CONVERTIBLE TOP DISASSEMBLY/ASSEMBLY.)
8. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
9. Install the battery cover.


< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.