Home

< Previous   Next >

2008 - MX-5 - Body and Accessories

SEAT WARMER UNIT INSPECTION

Seat Cushion

1. Remove the seat. (See SEAT REMOVAL/INSTALLATION.)
2. Remove the seat cushion trim. (See SEAT DISASSEMBLY/ASSEMBLY.)
3. Connect a jumper wire to the connector for the seat cushion warmer to seat back warmer.

4. While inspecting for continuity between the terminals A and B of the connector, use a dryer to warm the thermostat of the seat warmer unit on seat cushion.

5. Verify that the continuity between the seat warmer terminals is as indicated in the table.

Seat Back

1. Remove the seat. (See SEAT REMOVAL/INSTALLATION.)
2. Remove the seat back trim. (See SEAT DISASSEMBLY/ASSEMBLY.)
3. Verify that the continuity between the seat warmer terminals is as indicated in the table.



< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.