Home

< Previous   Next >

2008 - MX-5 - Body and Accessories

NO.1 CD PLAYER/CHANGER DOES NOT LOAD THE CD OR EJECTS THE CD IMMEDIATELY [AUDIO]



1

CD player/changer does not load the CD or ejects the CD immediately

Possible DTC: 03:Er01, 03:Er10, 06:Er01, 06:Er10, 10:Er01, 10:Er10, 22:Er01, 22:Er10

    Troubleshooting hints
  • CD is inserted upside down

  • Audio unit is malfunctioning

  • Defective CD (e.g., cracked, badly bent, rough edges, scratch, dirty CD, condensation)

  • Non-conventional discs (e.g., 8 cm (3 in) CD, 8 cm (3 in) disc adapter, heart-shaped disc, octagonal disc)

  • Poor connection of audio unit connector or terminal (e.g., damaged, bent, pulled-out pin, corrosion)

  • Deformed disc is used (e.g., out of specification (thickness), bent disc)


Diagnostic procedure

STEP

INSPECTION

ACTION

1

  • Is CD inserted properly, label-side up?

Yes

Go to the next step.

No

Explain to the customer that the CD should be inserted into the slot label-side up.

2

  • Replace with a CD known to be operational.

  • Does the CD player/changer load the CD?

Yes

Go to the next step.

No

Replace the audio unit.

(See CENTER PANEL UNIT REMOVAL/INSTALLATION.)

(See CENTER PANEL UNIT DISASSEMBLY/ASSEMBLY.)

(See AUDIO UNIT DISASSEMBLY/ASSEMBLY.)

3

Visually inspect the CD.

  • Is there any dirt, scratches or deformation on the CD?

  • Is the CD a non-conventional disc?

Yes

Explain to the customer that the defective CD or non-conventional disc cannot be used.

No

Go to the next step.

4

  • Turn the ignition switch to the LOCK position.

  • Inspect the connection of the audio unit connector (24-pin).

  • Inspect both the audio unit connector and wiring harness-side connector for a poor connection. (such as damaged/bent/pulled-out pins, corrosion)

  • All the pins and connector normal?

Yes

Replace the audio unit.

(See CENTER PANEL UNIT REMOVAL/INSTALLATION.)

(See CENTER PANEL UNIT DISASSEMBLY/ASSEMBLY.)

(See AUDIO UNIT DISASSEMBLY/ASSEMBLY.)

No

    If the wiring harness-side connector/pin is malfunctioning:
  • Repair or replace the pins and/or the connector.




< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.