Home

< Previous   Next >

2008 - MX-5 - Body and Accessories

NO. 10 OIL PRESSURE GAUGE INDICATION IS DEFECTIVE (OIL PRESSURE GAUGE NEEDLE DOES NOT MOVE FROM THE L POSITION OR LESS) [INSTRUMENT CLUSTER]



10

Oil pressure gauge indication is defective (oil pressure gauge needle does not move from the L position or less)

POSSIBLE CAUSE

  • PCM malfunction

  • Instrument cluster malfunction

  • Oil pressure switch malfunction

  • Connector or pin malfunction

  • Short circuit in wiring harness between CAN-L, CAN-H and GND

  • Open circuit in CAN wiring harness (CAN-L, CAN-H)

  • CAN wiring harness (CAN-L, CAN-H) short each other


Diagnostic procedure

STEP

INSPECTION

ACTION

1

  • Start the engine.

  • Does the oil pressure gauge needle indicate L position or more?

Yes

Troubleshooting completed.

No

Go to the next step.

2

  • Do the speedometer, the tachometer, and the water temperature gauge operate normally?

Yes

Go to the next step.

No

Go to Step 5.

3

  • Does the engine oil need replenishment?

Yes

Add the engine oil.

No

Go to the next step.

4

  • Start the instrument cluster input/output check mode.

  • Inspect the oil pressure gauge using the check code 28.

  • Is the oil pressure gauge normal?

Yes

Inspect the PCM, oil pressure switch, or connectors.

No

Replace the instrument cluster.

5

  • Start the engine.

  • Does the ABS warning light turn off?

Yes

Inspect the PCM or connectors.

No

Go to the next step.

6

  • Disconnect the negative battery cable.

  • Measure the resistance between the DLC-2 terminals F and E.

  • Is the resistance 54—66 ohms?

Yes

Go to the next step.

No

Go to Step 8.

7

  • Disconnect the negative battery cable.

  • Inspect the DLC-2 terminals F and E for short to power supply or GND.

  • Is there any malfunction?

Yes

Inspect the wiring harness and CAN system-related module.

Repair or replace the malfunctioning part.

No

Replace the instrument cluster.

8

  • Turn the ignition switch off.

  • Inspect the instrument cluster connector terminals for poor connection (such as damaged/pulled-out pins, and corrosion).

  • Are the terminals normal?

Yes

Go to the next step.

No

Repair or replace the terminal.

9

  • Disconnect the negative battery cable.

  • Measure the resistance between the instrument cluster connector terminals 1J and 1L.

  • Is the resistance 114—126 ohms?

Yes

Inspect the wiring harness and CAN system-related module.

Repair or replace the malfunctioning part.

No

Replace the instrument cluster.




< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.