Home

< Previous   Next >

2008 - MX-5 - Restraints

SIDE AIR BAG SENSOR REMOVAL/INSTALLATION

WARNING:

1. Turn the ignition switch to the LOCK position.
2. Remove the battery cover.
3. Disconnect the negative battery cable and wait for 1 min or more. (See BATTERY REMOVAL/INSTALLATION [LF].)
4. Remove the quarter trim. (See QUARTER TRIM REMOVAL/INSTALLATION.)
5. Remove the scuff plate. (See SCUFF PLATE REMOVAL/INSTALLATION.)
6. Remove the tire house trim. (See TIRE HOUSE TRIM REMOVAL/INSTALLATION.)
7. Remove in the order indicated in the table.



1

Connector

2

Bolt

3

Side air bag sensor


8. Install in the reverse order of removal.
9. Turn the ignition switch to the ON position and hold for 5 s or more.
10. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.