Home

< Previous   Next >

2008 - MX-5 - Restraints

CRASH ZONE SENSOR REMOVAL/INSTALLATION

WARNING:

1. Turn the ignition switch to the LOCK position.
2. Remove the battery cover.
3. Disconnect the negative battery cable and wait for 1 min or more. (See BATTERY REMOVAL/INSTALLATION [LF].)
4. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION.)
5. Remove the fresh-air duct. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF].)
6. Remove in the order indicated in the table.



1

Bolt A

2

Cover

3

Connector

4

Bolt B

5

Crash zone sensor


7. Install in the reverse order of removal.
8. Turn the ignition switch to the ON position.
9. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.