Home

< Previous   Next >

2008 - MX-5 - Steering

POWER STEERING OIL PUMP DISASSEMBLY/ASSEMBLY

NOTE:

1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.



1

Power steering oil pump component

(See Power Steering Oil Pump Component Disassembly Note.)

2

Pressure switch component

3

Pressure pipe fitting

4

O‐ring

5

Control valve

6

Spring

7

Suction pipe

8

O‐ring

9

Rear pump body

(See Rear Pump Body Assembly Note.)

10

Gasket

11

Clip

12

Cam ring

(See Cam Ring Assembly Note.)

13

Rotor

14

Vane

(See Vane Assembly Note.)

15

Side plate

16

O‐rings

17

Shaft component

18

Oil seal

(See Oil Seal Assembly Note.)

19

Front pump body


Power Steering Oil Pump Component Disassembly Note

1. Secure the power pressure oil pump using the SST.

CAUTION:

Oil Seal Assembly Note

1. Install the oil seal in the front pump body using the SST and plastic hammer.

Vane Assembly Note

1. Place the vanes in the rotor with the rounded edges contacting the cam.

Cam Ring Assembly Note

1. Install the cam ring in the front pump body with the mark facing upward.

Rear Pump Body Assembly Note

1. After installing the rear body, manually turn the shaft to verify that it rotates smoothly.


< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.