Home

< Previous   Next >

2008 - MX-5 - Transmission/Transaxle

CONTROL VALVE BODY INSTALLATION [SJ6A-EL]

On-Vehicle Installation

CAUTION:

1. Install the accumulator valve and compression springs to the transmission case.

CAUTION:

2. Coat the new O-rings with ATF, and install it to the accumulator piston (C-3).
3. Install the accumulator piston (C-3) and the compression spring to the transmission case.

4. Coat the new O-rings with ATF, and install it to the accumulator pistons (C-2, B-3).
5. Install the compression springs and the snap rings to the accumulator pistons (C-2, B-3) using a flathead screwdriver.
6. Install the accumulator pistons (C-2, B-3) and the compression springs to the transmission case.

7. Coat the new transmission gaskets and the new brake drum gaskets with ATF, and install it to the transmission case.

CAUTION:

8. Install the check valve sub-component and the compression spring to the transmission case.

9. Connect the manual valve link and install the control valve body component.

CAUTION:

10. Temporarily install the control valve body component with the bolts.

NOTE:

11. Tighten the bolts.
12. Install the detent spring cover and detent spring with the bolt to the control valve body component.
13. Install the TFT sensor and the lock plate with the bolt to the control valve body component.
14. Connect the coupler component to the clamps.

15. Connect the solenoid connectors to the solenoids.
16. Coat a new O-ring with ATF and install it to the oil strainer.
17. Install the oil strainer with the bolts to the control valve body component.

CAUTION:

18. Clean the contact surface of oil pan and transmission case.

NOTE:

19. Install the magnets to the oil pan.

CAUTION:

20. Install a new oil pan gasket and the oil pan to the transmission case.

CAUTION:

21. Install the bolts to the transmission case.
22. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
23. Install the battery cover.
24. Add ATF and, with the engine idling, inspect the ATF level and for leakage. (See AUTOMATIC TRANSMISSION FLUID (ATF) LEVEL ADJUSTMENT [SJ6A-EL].)
25. Perform the mechanical system test. (See MECHANICAL SYSTEM TEST [SJ6A-EL].)
26. Perform the road test. (See ROAD TEST [SJ6A-EL].)


< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.