Home

< Previous   Next >

2008 - MX-5 - Transmission/Transaxle

SOLENOID VALVE INSPECTION [SJ6A-EL]

CAUTION:

Resistance inspection (On-vehicle)

1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
3. Disconnect the solenoid valve connector.

4. Measure the resistance between the following terminals.

Solenoid valve resistance (ATF temperature: 20 °C {68 °F})

Terminals

Solenoid valve

Resistance (ohm)

O—GND

Shift solenoid A

5.0—5.6

N—GND

Shift solenoid B

5.0—5.6

M—GND

Shift solenoid C

5.0—5.6

L—GND

Shift solenoid D

5.0—5.6

K—GND

Shift solenoid E

5.0—5.6

E—F

Shift solenoid F

5.0—5.6

C—D

Shift solenoid G

5.0—5.6

I—J

Line pressure control solenoid

5.0—5.6

G—H

TCC control solenoid

5.0—5.6


5. Connect the solenoid valve connector.
6. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
7. Install the battery cover.

Continuity Inspection (On-Vehicle Inspection)

CAUTION:

1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
3. Disconnect the solenoid valve connector.

4. Verify that there is no continuity between coupler component terminals C, D, E, F, G, H, I, J and GND.
5. Connect the solenoid valve connector.
6. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
7. Install the battery cover.


< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.