Home

< Previous   Next >

2008 - MX-5 - Transmission/Transaxle

TRANSMISSION RANGE (TR) SWITCH INSPECTION [SJ6A-EL]

Operating inspection

1. Verify that the starter operates only when the ignition switch is turned to the START position with the selector lever in the P or N position.
2. Verify that the back-up lights illuminate when shifted to the R position with the ignition switch at the ON position.
3. Verify that the positions of the selector lever and the indicator are aligned.

Continuity Inspection

CAUTION:

1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
3. Remove the tunnel member component.
4. Remove the middle pipe. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [LF].)
5. Remove the insulator.

6. Disconnect the TR switch connector.

7. Verify that the continuity is as indicated in the table.

8. Reinspect for continuity at TR switch.
9. Connect the TR switch connector.
10. Install the insulator.
11. Install the middle pipe. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [LF].)
12. Install the tunnel member component.
13. Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
14. Install the battery cover.


< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.