Home

< Previous   Next >

2008 - MX-5 - Transmission/Transaxle

CLUTCH PEDAL REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Fully depress the clutch pedal, and verify that the engine starts.



1

CPP switch connector

2

CPP switch

3

Starter interlock switch connector

4

Starter interlock switch

(See Starter Interlock Switch Installation Note.)

5

Nut cap / Clip

(See Nut Cap Removal Note.)

6

Nut

7

Clutch pedal component

(See Clutch Pedal Component Installation Note)

8

Retaining ring

9

Joint pin

10

Bush

11

Nut

12

Push rod

13

Fork

14

Pedal pad

15

Clutch pedal


Nut Cap Removal Note

1. Dispose of the nut cap after removal.

NOTE:

Clutch Pedal Component Installation Note

CAUTION:

1. Install the clutch pedal component, and then temporarily tighten the nut A.

2. Insert the clip completely so that the clutch pedal adheres to the installation surface and there are no gaps between them.
3. Tighten the nuts B(2).

4. Tighten the nut A.
5. After installing the clutch pedal component, adjust/inspect the clutch pedal. (See CLUTCH PEDAL INSPECTION/ADJUSTMENT.)

Starter Interlock Switch Installation Note

CAUTION:

1. Insert a new starter interlock switch into the pedal bracket hole in direction A.
2. While pushing the starter interlock switch in direction A, slide it in direction B until it locks securely.
3. Fully depress the clutch pedal in the direction of arrow C, and verify that a click sound from the starter interlock switch is heard.



< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.