Home

< Previous   Next >

2008 - MX-5 - Transmission/Transaxle

DTC P0604 [SJ6A-EL]



DTC P0604

RAM malfunction

DETECTION CONDITION

  • RAM (in TCM) read/write error is detected.

    Diagnostic support note:
  • The MIL illuminates if the TCM detects the above malfunction condition during the first drive cycle.

  • A PENDING CODE is not available.

  • FREEZE FRAME DATA is available.

  • The AT warning light illuminates.

  • The DTC is stored in the TCM memory.

POSSIBLE CAUSE

  • TCM malfunction


Diagnostic procedure

STEP

INSPECTION

ACTION

1

VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
  • Has the FREEZE FRAME DATA been recorded?

Yes

Go to the next step.

No

Record the FREEZE FRAME DATA on the repair order, then go to the next step.

2

VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.

  • Is any related repair information available?

Yes

Perform repair or diagnosis according to the available repair information.

  • If the vehicle is not repaired, go to the next step.

No

Replace the TCM, then go to the next step.

(See TCM REMOVAL/INSTALLATION [SJ6A-EL].)

3

VERIFY TROUBLESHOOTING OF DTC P0604 COMPLETED
  • Make sure to reconnect all the disconnected connectors.

  • Clear the DTC from the memory using the M-MDS.

  • Drive the vehicle in D range and make sure that gears shift smoothly from 1GR to 6GR.

  • Is same DTC present?

Yes

Replace the TCM, then go to the next step.

(See TCM REMOVAL/INSTALLATION [SJ6A-EL].)

No

Go to the next step.

4

VERIFY AFTER REPAIR PROCEDURE
  • Are any DTCs present?

Yes

Go to the applicable DTC inspection.

(See DTC TABLE [SJ6A-EL].)

No

Troubleshooting completed.




< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.