Home

< Previous   Next >

2008 - MX-5 - Brakes

STEERING ANGLE SENSOR INSPECTION

1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION.)
2. Measure the voltage between steering angle sensor terminal B and ground.

3. Turn the ignition switch to the ON position, then measure the voltage between steering angle sensor terminal A and ground.
4. Measure the voltage between steering angle sensor terminal H and the ground.
5. Turn the ignition switch off.
6. Connect the M-MDS to the DLC-2.

7. Select the SWA_POS PID.
8. Verify the SWA_POS changes when the steering wheel is turned to the left and right.


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.