Home

< Previous   Next >

2008 - MX-5 - Brakes

BRAKE FLUID PRESSURE SENSOR INSPECTION

1. Turn the ignition switch off.
2. Install the SSTs to the master cylinder.

NOTE:

3. Bleed the air from the SSTs and the brake line. (Bleed air from the SSTs through air bleeding valve A.)
4. Connect the M-MDS to the DLC-2.

5. Select the MCYLI P PID.
6. Start the engine.
7. Depress the brake pedal, and confirm that the fluid pressure value of the SST (Gauge) and the value shown on the M-MDS are equal.


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.