Home

< Previous   Next >

2008 - MX-5 - Brakes

ABS HU/CM REMOVAL/INSTALLATION

CAUTION:

1. Perform ABS configuration. (See ABS CONFIGURATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.



1

ABS HU/CM connector

(See ABS HU/CM Connector Removal Note.)

(See ABS HU/CM Connector Installation Note.)

2

Brake pipe

(See Brake Pipe Removal Note.)

(See Brake Pipe Installation Note.)

3

Nut

4

ABS HU/CM, brake pipe

5

Brake pipe (ABS HU/CM—brake pipe joint)

(See Brake Pipe (ABS HU/CM—brake pipe joint) Installation Note.)

6

ABS HU/CM


ABS HU/CM Connector Removal Note

1. Pull the lock lever up in the direction of the arrow.

2. Pull the connector toward the vehicle rear and remove it.

Brake Pipe Removal Note

1. Place an alignment mark on the brake pipe and ABS HU/CM.

2. Apply protective tape to the connector to prevent brake fluid from entering.
3. Remove the brake pipe.

Brake Pipe (ABS HU/CM—brake pipe joint) Installation Note

1. Align with the mark made before removing the brake pipe and temporarily install the brake pipe to the ABS HU/CM.

CAUTION:

Brake Pipe Installation Note

1. Align the marks made before removal and install the brake pipe to the ABS HU/CM and brake pipe joint referring to the figure.

2. Tighten the brake pipe to the specified torque using the commercially available flare nut wrench.

ABS HU/CM Connector Installation Note

1. After connecting the connector, verify that the lock lever is completely pushed in.



< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.