Home

< Previous   Next >

2008 - MX-5 - Brakes

REAR ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION

1. Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION.)
2. Remove the partition board. (See PARTITION BOARD REMOVAL/INSTALLATION.)
3. Remove the trunk side trim. (See TRUNK SIDE TRIM REMOVAL/INSTALLATION.)
4. Remove the fuel-filler pipe protector. (See FUEL TANK REMOVAL/INSTALLATION [LF].)
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.



1

Connector

2

Bolt

3

Rear ABS wheel-speed sensor




< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.