Home

< Previous   Next >

2008 - MX-5 - Brakes

POWER BRAKE UNIT REMOVAL/INSTALLATION

CAUTION:

1. Remove the master cylinder. (See MASTER CYLINDER REMOVAL/INSTALLATION.)
2. Remove the clutch pipe. (MT)

3. Remove the nut shown in the figure, then remove the cooler hose (LO) bracket from the vehicle.

4. Remove in the order indicated in the table.
5. Remove the brake switch. (See BRAKE PEDAL REMOVAL/INSTALLATION.)
6. Install in the reverse order of removal.
7. After installation, perform brake pedal inspection. (See BRAKE PEDAL INSPECTION.)



1

Vacuum hose

2

Snap pin

3

Clevis pin

4

Nut

5

Power brake unit

6

Gasket

7

Fork

8

Locknut




< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.