Home

< Previous   Next >

2008 - MX-5 - Brakes

BRAKE PEDAL REMOVAL/INSTALLATION

CAUTION:

NOTE:

1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.



1

Brake switch connector

(See Brake Switch Connector Installation Note.)

2

Brake switch

(See Brake Switch Installation Note.)

3

Snap pin

4

Clevis pin

5

Interlock cable (AT)

(See SELECTOR LEVER REMOVAL/INSTALLATION.)

6

Brake pedal

(See Brake Pedal Removal Note.)

7

Pedal pad


Brake Pedal Removal Note

1. Move the power brake unit to the vehicle front where the power brake unit fork does not interfere with the brake pedal arm.
2. Remove the brake pedal.

Brake Switch Installation Note

1. Install the new brake switch to the brake pedal (MT) or the interlock cable (AT), and secure it by turning it clockwise 45° (AT) or counterclockwise 45° (MT).

Brake Switch Connector Installation Note

1. Inspect the brake pedal. (See BRAKE PEDAL INSPECTION.)
2. With the brake pedal in its original position, install the brake switch to the brake switch connector.


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.