Home

< Previous   Next >

2008 - MX-5 - Brakes

GENERAL PROCEDURES (BRAKE)

Wheel and Tire Installation

1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque.

Brake Lines Disconnection

1. If any brake line has been disconnected anytime during the procedures, add brake fluid, bleed the brakes, and inspect for leakage after the procedure has been completed.

CAUTION:

Brake Pipe Flare Nut Tightening

1. Tighten the brake pipe flare nut using the commercially available flare nut wrench.

Connector Disconnection

1. Disconnect the negative battery cable before performing any work that requires handling of connectors. (See BATTERY REMOVAL/INSTALLATION [LF].)

ABS/DSC Related Parts

1. Make sure that there are no DTCs in the ABS/DSC memory after working on ABS/DSC related parts. If there are any codes in the memory, clear them.

DSC Related Part Sensor Initialization Procedure

WARNING:

1. When replacing or removing the following parts, perform the initialization procedure. (See COMBINED SENSOR INITIALIZATION PROCEDURE.) (See STEERING ANGLE SENSOR INITIALIZATION PROCEDURE.) (See STEERING ANGLE SIGNAL INITIALIZATION PROCEDURE.)


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.