Home

< Previous   Next >

2008 - MX-5 - Brakes

DTC C1306 [DYNAMIC STABILITY CONTROL (DSC)]

NOTE:



DTC

C1306

Steering angle sensor (abnormal initialization) system

DETECTION CONDITION

  • The steering angle sensor detects that the initialization procedure has not been performed.

POSSIBLE CAUSE

  • The initialization procedure for the steering angle sensor has not been performed.

  • Steering angle sensor malfunction

  • The negative battery cable connector was disconnected previously.

  • The steering angle sensor connector was disconnected previously.

  • The fuse (ROOM 15A) was removed previously.


Diagnostic procedure

STEP

INSPECTION

ACTION

1

VERIFY INITIALIZATION PROCEDURE.
  • Has the steering angle sensor initialization procedure been performed?

Yes

Go to the next step.

No

Perform the steering angle sensor initialization procedure, then go to the next step. (See STEERING ANGLE SENSOR INITIALIZATION PROCEDURE.)

2

VERIFY DTC TROUBLESHOOTING COMPLETED

Yes

Repeat the inspection from Step 1.

If the malfunction occurs again, replace the steering angle sensor, then go to the next step.

(See STEERING ANGLE SENSOR REMOVAL/INSTALLATION.)

No

Go to the next step.

3

VERIFY AFTER REPAIR PROCEDURE
  • Are any other DTCs present?

Yes

Go to the applicable DTC inspection.

(See ON-BOARD DIAGNOSIS[DYNAMIC STABILITY CONTROL (DSC)].)

No

DTC troubleshooting completed.




< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.