Home

< Previous   Next >

2008 - MX-5 - Brakes

DTC B1484 [ABS]



DTC

B1484

Brake switch system

DETECTION CONDITION

  • Open circuit in the wiring harness between the ABS HU/CM terminal and the brake switch terminal

POSSIBLE CAUSE

  • Brake switch malfunction

  • Open circuit in the wiring harness between the ABS HU/CM terminal N and the brake switch terminal D


Diagnostic procedure

STEP

INSPECTION

ACTION

1

INSPECT ABS HU/CM TO BRAKE SWITCH FOR OPEN CIRCUIT
  • Turn the ignition switch off.

  • Disconnect the ABS HU/CM and brake switch connector.

  • Inspect for continuity ABS HU/CM terminal N and brake switch terminal D.

  • Is there continuity?

Yes

Go to the next step.

No

Repair or replace the wiring harness for open circuit between ABS HU/CM and brake switch, then go to the next step.

2

INSPECT BRAKE SWITCH

Yes

Go to the next step.

No

Replace the brake switch, then go to the next step.

(See BRAKE PEDAL REMOVAL/INSTALLATION.)

3

VERIFY TROUBLESHOOTING COMPLETED
  • Make sure to reconnect all disconnected connectors.

  • Clear the DTC from the memory.

    (See ON-BOARD DIAGNOSIS[ABS].)

  • Are the same DTCs present?

Yes

Replace the ABS HU/CM, then go to the next step.

(See ABS HU/CM REMOVAL/INSTALLATION.)

No

Go to the next step.

4

VERIFY AFTER REPAIR PROCEDURE
  • Are any other DTC present?

Yes

Go to the applicable DTC inspection.

(See ON-BOARD DIAGNOSIS[ABS].)

No

DTC troubleshooting completed.




< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.