Home

< Previous   Next >

2008 - MX-5 - DriveLine/Axle

WHEEL HUB, STEERING KNUCKLE REMOVAL/INSTALLATION

CAUTION:

1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, inspect front wheel alignment. (See FRONT WHEEL ALIGNMENT.)



1

ABS wheel-speed sensor

2

Brake caliper component

(See Brake Caliper Component Removal Note.)

3

Disc plate

4

Tie-rod end

(See STEERING GEAR AND LINKAGE REMOVAL/INSTALLATION.)

5

Stabilizer control link nut (lower)

6

Front upper arm ball joint

(See FRONT LOWER ARM REMOVAL/INSTALLATION.)

7

Front upper arm bolt

8

Front lower arm ball joint

(See FRONT LOWER ARM REMOVAL/INSTALLATION.)

9

Steering knuckle component

10

Steering knuckle

11

Dust cover

12

Wheel hub bolt

(See Wheel Hub Bolt Removal Note.)

(See Wheel Hub Bolt Installation Note.)

13

Wheel hub component


Brake Caliper Component Removal Note

1. Suspend the brake caliper component using a cable or equivalent.

Wheel Hub Bolt Removal Note

NOTE:

1. Remove the wheel hub bolts from the wheel hub using a press.

Wheel Hub Bolt Installation Note

1. Press in new wheel hub bolts into the wheel hub using a press.



< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.