Home

  Next >

2008 - MX-5 - DriveLine/Axle

GENERAL PROCEDURES (FRONT AND REAR AXLES)

Wheel And Tire Installation

1. When installing the wheels and tires, tighten the wheel nuts in a criss-cross pattern to the following tightening torque.

Connector Disconnection

1. Disconnect the negative battery cable before performing any work that requires handling of connectors. (See BATTERY REMOVAL/INSTALLATION [LF].)

Suspension Links Removal/Installation

1. For the joint sections with rubber bushings, raise the vehicle using a lift, and then temporarily tighten the installation bolts and nuts. Lower the vehicle to the ground and tighten them completely with the specified torque.



  Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.