Home

< Previous   Next >

2008 - MX-5 - Suspension

REAR STABILIZER REMOVAL/INSTALLATION

1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.



1

Stabilizer control link

(See Stabilizer Control Link Installation Note.)

2

Stabilizer bracket

3

Bushing

4

Rear stabilizer

(See Rear Stabilizer Installation Note.)


Rear Stabilizer Installation Note

1. Install the rear stabilizer so that the identification mark is on the right side of the vehicle.

Stabilizer Control Link Installation Note

1. Install the stabilizer control link in the proper angle as shown in the figure.

CAUTION:

2. Place the vehicle on the ground and verify that the stabilizer control link is installed in the angle shown in the figure.



< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.