Home

< Previous   Next >

2008 - MX-5 - Suspension

WHEEL ALIGNMENT PRE-INSPECTION

1. Park the vehicle on level ground, in an unloaded condition*, and with the wheels straight forward.
2. Inspect the tire pressure.
3. Inspect the wheel bearing play.
4. Inspect the wheel runout.
5. Rock the vehicle, and verify that there is no looseness in the steering wheel joint and suspension ball joint.
6. Rock the vehicle, and verify that the shock absorber operates properly.
7. Measure height H from the center of the wheel to the fender brim.

8. Verify that the difference between the left and right dimension H is within the specification.

*: Unloaded vehicle.....Fuel tank is full. Engine coolant and engine oil are at specified level. Jack and tools are in designated position.



< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.