Home

< Previous   Next >

2008 - MX-5 - Suspension

PRECAUTION

Intermittent Concern Troubleshooting

Vibration method

NOTE:

Inspection method for switch and/or sensor connectors or wires
1. Connect M-MDS to DLC-2.
2. Turn the ignition switch to the ON position (engine off).

NOTE:

3. Access PIDs for the switch you are inspecting.
4. Turn switch on manually.
5. Shake each connector or wire harness a bit vertically and horizontally while monitoring the PID.

Inspection method for sensors
1. Connect M-MDS to DLC-2.
2. Turn the ignition switch to the ON position (engine off).

NOTE:

3. Access PIDs for the switch you are inspecting.
4. Vibrate the sensor slightly with your finger.
Connector terminal check method
1. Check the connection condition of each female terminal.
2. Insert male terminal; fit the female terminal side to female terminal and check to see whether the malfunction is in the female terminal or not.



< Previous   Next >
Back to Top
© 2009 Mazda North American Operations, U.S.A.