Home

< Previous   Next >

2008 - MX-5 - Engine

THROTTLE POSITION (TP) SENSOR INSPECTION [LF]

CAUTION:

NOTE:

1. Verify that no DTC related to APP sensor has been detected.
2. Connect the M-MDS to the DLC‐2.

3. Turn the ignition switch to the ON position.
4. Select TP1 or TP2 PID (percentage) on the M-MDS.
5. Verify that the TP1 or TP2 PID is within the specification when the accelerator pedal not depressed. (See PCM INSPECTION [LF].)
6. Operate the accelerator pedal and verify that the TP1 or TP2 PID (percentage) changes as shown in the following graph.

Circuit Open/Short Inspection

1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [LF].)
2. Disconnect the throttle body connector.
3. Inspect the following wiring harnesses for an open or short circuit. (Continuity inspection)

Open circuit
Short circuit


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.