Home

< Previous   Next >

2008 - MX-5 - Engine

PCM REMOVAL/INSTALLATION [LF]

1. When replacing the PCM, perform the following:
2. Remove the battery cover.
3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
4. Remove the air cleaner case. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF].)
5. Move the water hose from the PCM cover slightly out of the way.
6. Remove in the order indicated in the table.



1

PCM cover

2

PCM connector

(See PCM REMOVAL/INSTALLATION [LF].)

3

PCM

4

Air cleaner insulator

5

PCM duct


7. Install in the reverse order of removal.
8. When replacing the PCM on the vehicles, perform the following:

PCM Connector Connected Note

1. Connect the PCM connector fully into the PCM and push the lever until a click is heard.



< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.