Home

< Previous   Next >

2008 - MX-5 - Engine

ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION [LF]

1. Remove the battery cover.
2. Disconnect the negative battery cable. (SeeBATTERY REMOVAL/INSTALLATION [LF].)
3. Drain the engine coolant from the radiator. (See ENGINE COOLANT REPLACEMENT [LF]
4. Remove the service hole cover.
a. Remove the suspension tower bar (joint), (right side) and (left side). (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION.)
b. Remove the wiper arm. (See WIPER ARM AND BLADE REMOVAL/INSTALLATION.)
c. Remove the cowl grille. (See COWL GRILLE REMOVAL/INSTALLATION.)
d. Remove the side cowl grille. (See SIDE COWL GRILLE REMOVAL/INSTALLATION.)
e. Move the cooler pipe No.3 and heater pipe slightly out of the way.

f. Remove the service hole cover. (See EGR VALVE REMOVAL/INSTALLATION [LF].)
5. Disconnect the heater hose and move the heater pipe slightly out of the way.

6. Disconnect the ECT sensor connector.
7. Remove the ECT sensor.

NOTE:

8. Install in the reverse order of removal.



< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.