Home

< Previous   Next >

2008 - MX-5 - Engine

CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION [LF]

NOTE:

Continuity Inspection

1. Remove the CPP switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION.)
2. Verify that the continuity between CPP switch terminals D and B is as indicated in the table.

Circuit Open/Short Inspection

1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [LF].)
2. Inspect the following wiring harness for open or short circuit (continuity Inspection).

Open circuit
Short circuit


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.