Home

< Previous   Next >

2008 - MX-5 - Engine

PURGE SOLENOID VALVE INSPECTION [LF]

NOTE:

Airflow Inspection

1. Remove the purge solenoid valve without disconnecting the evaporative hose. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION [LF].)
2. Verify that the airflow is as indicated in the table.



Measured condition

Continuity between A—B

When voltage is not applied between terminals A and B

No airflow

When voltage is applied between terminals A and B

Airflow detected


Circuit Open/Short Inspection

1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION [LF].)
2. Inspect the following wiring harnesses for open or short circuit (continuity check).



< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.