Home

< Previous   Next >

2008 - MX-5 - Engine

AFTER SERVICE PRECAUTION [LF]

WARNING:

Fuel Leakage Inspection

WARNING:

Using M-MDS
1. Connect the M-MDS to the DLC-2.

2. Start the fuel pump using the “FP” simulation function.
3. Verify that there is no fuel leakage from the pressurized parts.
4. After reinstallation, repeat step 2—3 in the fuel leakage inspection.
Not using SST (M-MDS)
1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
3. Short the check connector terminal F/P to ground using a jumper wire.

4. Connect the negative battery cable.
5. Turn the ignition switch to the ON position to operate the fuel pump.
6. Verify that there is no fuel leakage from the pressurized parts.
7. After reinstallation, repeat step 5—6 in the fuel leakage inspection.


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.