Home

< Previous   Next >

2008 - MX-5 - Engine

WATER PUMP REMOVAL/INSTALLATION [LF]

WARNING:

1. Remove the battery cover.
2. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [LF].)
3. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT [LF].)
4. Remove the air cleaner. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [LF].)
5. Loosen the water pump pulley bolt and remove the drive belt. (See DRIVE BELT REPLACEMENT [LF].)
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
8. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT [LF].)
9. Inspect for engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION [LF].)



1

Water pump pulley

2

Water pump

3

O-ring




< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.