Home

< Previous   Next >

2008 - MX-5 - Engine

DTC P2610 [LF]



DTC P2610

PCM internal engine off timer performance

DETECTION CONDITION

  • PCM internal engine off timer is damaged.

    Diagnostic support note
  • This is a continuous monitor (CCM).

  • The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.

  • PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.

  • FREEZE FRAME DATA is available.

  • The DTC is stored in the PCM memory.

POSSIBLE CAUSE

  • PCM internal engine off timer is damaged.


Diagnostic procedure

STEP

INSPECTION

ACTION

1

VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
  • Has the FREEZE FRAME DATA been recorded?

Yes

Go to the next step.

No

Record the FREEZE FRAME DATA on the repair order, then go to the next step.

2

VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.

  • Is any related repair information available?

Yes

Perform repair or diagnosis according to the available repair information.

  • If the vehicle is not repaired, go to the next step.

No

Go to the next step.

3

VERIFY TROUBLESHOOTING OF DTC P2610 COMPLETED
  • Make sure to reconnect all the disconnected connectors.

  • Clear the DTC from the PCM memory using the M-MDS.

  • Start the engine.

  • Is the same DTC present?

Yes

Replace the PCM, then go to the next step.

(See PCM REMOVAL/INSTALLATION [LF].)

No

Go to the next step.

4

VERIFY AFTER REPAIR PROCEDURE

Yes

Go to the applicable DTC troubleshooting.

(See DTC TABLE [LF].)

No

DTC troubleshooting completed.




< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.