Home

< Previous   Next >

2008 - MX-5 - Engine

DTC P0602 [LF]



DTC P0602

PCM programming error

DETECTION CONDITION

  • No configuration data in the PCM

NOTE:

  • If the “PCM CONFIGURATION” is successful, the PCM stores DTC P0602 and illuminates the MIL (system is normal). Clear DTC P0602 using the M-MDS after the “PCM CONFIGURATION”.

  • The MIL goes out after three drive cycles with no failure (DTCs remain in PCM).

    Diagnostic support note
  • This is a continuous monitor (CCM).

  • The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.

  • PENDING CODE is available if the PCM detects the above malfunction condition.

  • FREEZE FRAME DATA is available.

  • The DTC is stored in the PCM memory.

POSSIBLE CAUSE

  • Configuration has not been completed

  • PCM malfunction


Diagnostic procedure

STEP

INSPECTION

ACTION

1

VERIFY FREEZE FRAME DATA HAS BEEN RECORDED
  • Has FREEZE FRAME DATA been recorded?

Yes

Go to the next step.

No

Record the FREEZE FRAME DATA on the repair order, then go to the next step.

2

VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability.

  • Is any related repair information available?

Yes

Perform repair or diagnosis according to the available repair information.

  • If the vehicle is not repaired, go to the next step.

No

Go to the next step.

3

VERIFY TROUBLESHOOTING OF DTC P0602 COMPLETED
  • Make sure to reconnect all disconnected connectors.

  • Turn the ignition switch to the ON position (Engine off).

  • Clear the DTC from the PCM memory using the M-MDS.

  • Perform the HO2S heater, HO2S, and TWC Repair Verification Drive Mode. (See OBD-II DRIVE MODE [LF].)

  • Is the same DTC present?

Yes

Replace the PCM, then go to the next step.

(See PCM REMOVAL/INSTALLATION [LF].)

No

Go to the next step.

4

VERIFY AFTER REPAIR PROCEDURE

Yes

Go to the applicable DTC troubleshooting.

(See DTC TABLE [LF].)

No

Troubleshooting completed.




< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.