Home

< Previous   Next >

2008 - MX-5 - Engine

ON-BOARD DIAGNOSTIC TEST [LF]

DTC Reading Procedure

1. Connect the M-MDS to the DLC‐2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
3. Select the “Retrieve CMDTCs” and perform procedures according to directions on the M-MDS screen.
4. Verify the DTC according to the directions on the M-MDS screen.
5. After completion of repairs, clear all DTCs stored in the PCM, while referring to “AFTER REPAIR PROCEDURE“.

Pending Trouble Code Access Procedure

1. Connect the M-MDS to the DLC‐2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
3. Then, select the “Retrieve CMDTCs” and perform procedures according to directions on the M-MDS screen.
4. Retrieve the pending trouble codes according to the directions on the M-MDS screen.

Freeze Frame PID Data Access Procedure

1. Connect the M-MDS to the DLC‐2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
3. Then, select the “Retrieve CMDTCs” and perform procedures according to directions on the M-MDS screen.
4. Retrieve the freeze frame PID data according to the directions on the M-MDS screen.

On-Board System Readiness Tests Access Procedure

1. Connect the M-MDS to the DLC‐2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
3. Then, select the “***SUP” and “**EVAL” PIDs in the PID selection screen.
4. Monitor those PIDs and check it system monitor is completed.

NOTE:

PID/DATA Monitor and Record Procedure

NOTE:

1. Connect the M-MDS to the DLC‐2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
3. Select the applicable PID from the PID table.
4. Verify the PID data according to the detections on the screen.

Diagnostic Monitoring Test Results Access Procedure

1. Connect the M-MDS to the DLC‐2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
3. Verify the diagnostic monitoring test result according to the directions on the screen.

Active Command Modes Procedure

1. Connect the M-MDS to the DLC‐2.

2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
3. Select the simulation items from the PID table.
4. Perform the simulation function, inspect the operations for each parts.


< Previous   Next >
Back to Top
© 2012 Mazda North American Operations, U.S.A.